Knowledge Base
In order to create a “V-Form” progressive strip layout, one where the part is v-formed at the end of the die as the part is cutoff, you must use a split line in the middle of the bend and then you should unbend the part on each side of the split line. That is the key in order to have this ...
Topics
- -IMPORTANT-1- info for LP users
- -IMPORTANT-2- info for LP users
- LP 123GO Light
- LP 123GO Full
- LP How-To's for users
- LP Standard Components
- LP tips & tricks
- LP Unbending
- LP Warning messages
- SolidWorks tips & tricks
- General tips & tricks for all
- Windows tips & tricks
- A great use for WAX (stretch webs)
- Computer performance
- Computer benchmark
- Software we use
- FREE software
- Uncategorized