The LogoPress help file recommends that when using “Unbending by steps”, you should pick the inside radius. But in reality, it really doesn’t matter which you pick. I almost always pick the outside radius myself, because it is always obviously a bigger target and is always closer to you. But ...

I’ve had this chart shown below for well over a dozen years. I’ve found it to be very useful for quickly adding a symbol to the document you are working on; particularly when working with emails describing things such as diameters and plus/minus dimension and angles. The trick is to simpy hold ...

3D CAD software certainly requires more overhead than 2D CAD software that simply draws lines and circles. After purchasing the right software and proper training, the next part of the equation is certainly the most overlooked in my opinion. The disappointing part of it being overlooked is that it ...